Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 326
9 - Mirror Glass
❑ Removing and installing. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
.
10 - Turn Signal
❑ Removing and installing. Refer to ⇒ Electrical Equipment; Rep. Gr. 94 ; Exterior Rearview Mirror Lamps;
Turn Signal, Removing and Installing .
11 - Bolt
❑ 1 Nm
❑ Quantity: 2
12 - Mirror Cap
❑ Material: ABS
❑ Removing and installing. Refer to
⇒ “7.5 Mirror Cap, Removing and Installing”, page 442
.
7.2
Exterior Rearview Mirror, Removing and
Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left exterior rearview mirror. The right side is identical.
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– Unclip the cover -3- and while doing so, loosen the adhesive
tape -4-.
– Disconnect the connector -8- from the exterior mirror -1-.
– Remove the door control module -7- and loosen the installed
clip -arrows-. Refer to
⇒ “3.2 Driver Door Control Module J386 and Front Passenger
Door Control Module J387 , Removing and Installing”,
.
– Guide the wire -6- through the opening in the door.
– Remove the bolts -5- for the exterior rearview mirror -1- and
remove the exterior rearview mirror -1-.
Installing
Install in reverse order of removal. Note the following:
– If the adhesive tape or clip is damaged replace the cover -3-.
– Perform a function test before installing the front door trim
panel.
Tightening Specifications
7.3
Mirror Glass, Removing and Installing
Special tools and workshop equipment required
♦ Pry Lever - 80-200-
Note
The following describes the removal and installation of the left mirror glass. The right side is identical.
Removing
WARNING
Wear protective eyewear and safety gloves when working.
– Protect the housing edge from paint damage, for example by
using fabric-reinforced adhesive tape.
– Press the mirror glass -1- into the mirror housing at the bottom.
– Press the mirror glass -1- from the adjusting unit -2- using the
Pry Lever - 80-200- .
– Move the mirror glass -1- to the side and disconnect the con‐
nectors -3- for the mirror heater on the back of the mirror glass
-1-.
Installing
– Connect the connectors -3- to the mirror glass -1-.
– Press the center of the mirror glass -1- onto the adjusting unit
-2- in the housing.
The mirror glass will engage with a click.
Note
Only press the center of the mirror when pressing the mirror glass on.
– Then perform a function test.
7.4
Mirror Adjuster, Removing and Installing
⇒ “7.4.1 Mirror Adjuster, Removing and Installing, Version A”,
page 439
⇒ “7.4.2 Mirror Adjuster, Removing and Installing, Version B”,
7.4.1
Mirror Adjuster, Removing and Instal‐
ling, Version A
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left adjusting unit with motor. The right side is iden‐
tical.
Removing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст