Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 325
– Loosen the rear underbody panel and push it slightly down‐
ward. Refer to
⇒ “5.2 Underbody Panels, Removing and Installing”,
– Remove the nuts -2-.
– Remove the rear tunnel brace -1-.
Installing
Install in reverse order of removal.
Tightening Specifications
6
Roof Bars/Roof Rails
⇒ “6.1 Overview - Roof Railing”, page 433
⇒ “6.2 Roof Railing, Removing and Installing”, page 434
6.1
Overview - Roof Railing
1 - Roof Railing
❑ Left and right
❑ Removing and instal‐
ling. Refer to
.
2 - Seal
❑ Roof railing component
3 - Hex Nut
❑ 9 Nm
❑ Quantity: 4 on each side
6.2
Roof Railing, Removing and Installing
Removing
– Remove the headliner. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Roof Trim Panels; Headliner, Removing and Installing .
– Remove the front and rear hex nuts -3-.
– Remove the roof railing -1- straight upward.
Installing
– Check the seal -2- for damage and make sure it is positioned
correctly.
– Place the roof railing -1- on straight from above.
– Tighten the front and rear hex nuts -3-.
Tightening Specifications
7
Exterior Rearview Mirror
⇒ “7.1 Overview - Exterior Rearview Mirror”, page 435
⇒ “7.2 Exterior Rearview Mirror, Removing and Installing”,
page 436
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
⇒ “7.4 Mirror Adjuster, Removing and Installing”, page 439
⇒ “7.5 Mirror Cap, Removing and Installing”, page 442
⇒ “7.6 Mirror Trim, Removing and Installing”, page 443
7.1
Overview - Exterior Rearview Mirror
Note
The illustration shows the left side. The right side is identical.
1 - Mirror Base
❑ Removing and instal‐
ling. Refer to
.
2 - Bolt
❑ 9 Nm
❑ Quantity: 2
3 - Clip
4 - Cap
Removing and installing. Refer
to
ror, Removing and Installing”,
5 - Adjusting Unit
❑ Removing and instal‐
ling. Refer to
.
6 - Bolt
❑ 1 Nm
7 - Mirror Trim
❑ Removing and instal‐
ling. Refer to
.
8 - Bolt
❑ 1 Nm
❑ Quantity: 2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст