Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 220
Note
The following describes the removal and installation of the left fender. Removing and installing the right fender
is identical.
Removing
– Remove the front wheel housing liner. Refer to
⇒ “8.4 Front Wheel Housing Liner, Removing and Installing”,
– Remove the front bumper cover. Refer to
⇒ “1.5 Bumper Cover, Removing and Installing”, page 317
– Remove the headlamps. Refer to ⇒ Electrical Equipment;
Rep. Gr. 94 ; Headlamp; Headlamp, Removing and Installing .
– Remove the left plenum chamber cover. Refer to
⇒ “3.4 Plenum Chamber Cover, Removing and Installing”,
.
– Remove the drip rail. Refer to
⇒ “3.4 Drip Rail, Removing and Installing”, page 409
– Remove the hex nut -4- and then remove the guide -5-.
– Remove the fender noise insulation -item 5-
.
– Remove the brace insulation -item 4-
– Remove the double bolts -6-.
– Remove the bolts -2 and 3-.
– Carefully remove the fender -1-.
Note
The Zinc Spacer - AKL 381 035 50- -7- (if present) will be damaged during the removal.
Note
Install the fender -1- so that it is free of tension.
Installing
Install in reverse order of removal. Note the following:
– With the fender brace loosened, align the fender free of ten‐
sion. Refer to
⇒ “2.4 Fender Brace, Removing and Installing”, page 14
– Always insert the Zinc Spacer - AKL 381 035 50- -7- between
the fender and side sills.
– Note the parallel alignment and gap dimensions. Refer to
⇒ Body Repair; Rep. Gr. 00 ; Body Gap Dimensions; Front
Body .
Tightening Specifications
2.4
Fender Brace, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left fender brace. Removing and installing the right
fender brace is identical.
Removing
– Remove the front bumper cover. Refer to
⇒ “1.5 Bumper Cover, Removing and Installing”, page 317
.
– Remove the headlamps. Refer to ⇒ Electrical Equipment;
Rep. Gr. 94 ; Headlamp; Headlamp, Removing and Installing .
– Remove the guide for the front bumper cover -item 7-
.
– Remove the double bolts -item 8-
– Remove the bolts -2- and remove the fender brace -1-.
Installing
Install in reverse order of removal. Note the following:
– Adapt the fender brace and the fender to the hood and bump‐
er. Refer to ⇒ Body Repair; Rep. Gr. 00 ; Body Gap Dimen‐
sions; Front Body .
Tightening Specifications
Component
Tightening Specifica‐
tions
Fender brace to the body
6 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст