Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 221
3
Bulkhead
⇒ “3.1 Overview - Bulkhead”, page 16
⇒ “3.2 Overview - Plenum Chamber Cover”, page 17
⇒ “3.3 Bulkhead, Removing and Installing”, page 17
⇒ “3.4 Plenum Chamber Cover, Removing and Installing”,
3.1
Overview - Bulkhead
1 - Bulkhead
❑ Removing and instal‐
ling. Refer to
2 - Hex Nut
❑ 8 Nm
❑ Quantity: 2
3 - Bulkhead Seal
3.2
Overview - Plenum Chamber Cover
1 - Plenum Chamber Cover
❑ Right side
❑ Removing and instal‐
ling. Refer to
2 - Plenum Chamber Cover
❑ Left side
❑ Removing and instal‐
ling. Refer to
3 - Clip
❑ Quantity: 3
4 - Seal
5 - Binding Profile
❑ Windshield component
6 - Windshield
3.3
Bulkhead, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
– Remove the plenum chamber cover. Refer to
⇒ “3.4 Plenum Chamber Cover, Removing and Installing”,
.
– Remove the hex nuts -2- and the bulkhead -1-.
Installing
Install in reverse order of removal.
Tightening Specifications
3.4
Plenum Chamber Cover, Removing and Installing
Note
Removing and installing the plenum chamber cover may differ slightly depending on the model.
Removing
– Remove the wiper arms. Refer to ⇒ Electrical Equipment;
Rep. Gr. 92 ; Windshield Wiper System; Windshield Wiper
Arms, Removing and Installing .
– Remove the seal -4- from the entire length of the plenum
chamber covers -1 and 2-.
Caution
The windshield -6- could break. The plenum chamber cover
must not be pried off using a levering tool (screwdriver, wedge).
The windshield will be damaged and could crack later.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст