Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 222
– Unclip the clips -3- (quantity: 3).
– Starting in the center, first remove the plenum chamber cover
-2- upward out of the binding profile -5-.
– Pull the plenum chamber cover -2- forward out of the fender
and remove it.
– Then starting in the center remove the plenum chamber cover
-1- upward out of the binding profile -5-.
– Pull the plenum chamber cover -1- forward out of the fender
and remove it.
Installing
Caution
The windshield -6- could break.
Striking the plenum chamber cover to install it in the windshield
retainer can cause the windshield to crack.
Note
♦
New windshields have an insert in the retainer. Remove this insert before installing the plenum chamber
cover.
♦
Press the plenum chamber cover into the retainer gently by hand. Do not strike it or press on it with a tool
under any circumstances.
– Spray the retainer -5- with soapy water so that the plenum
chamber covers -1 and 2- can be pressed in more easily.
– First push the plenum chamber cover -1- into the fender.
– Place the plenum chamber cover -1- on the binding profile
-5-. Starting at the outside, gently push it into the binding profile
-5-.
– Then insert the plenum chamber cover -2- into the fender.
– Place the plenum chamber cover -2- on the binding profile
-5-. Starting at the outside, gently push it into the binding profile
-5-.
– Install the clips -3- (quantity: 3).
– Attach the seal -4- to the plenum chamber covers -1 and 2-.
– Install the wiper arms. Refer to ⇒ Electrical Equipment; Rep.
Gr. 92 ; Windshield Wiper System; Windshield Wiper Arms,
Removing and Installing .
4
Special Tools
Special tools and workshop equipment required
♦ Guide Pins - T10093-
♦ Adapters For Service Position - T10467-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Torque Wrench 1332 40-200Nm - VAG1332-
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст