Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 631
♦ Seal Installer - Selector Shaft Oil Seal - T10174-
♦ Puller - Crankshaft/Power Steering Seal - T20143/1-
♦ Engine Support - Basic Set Square Pipe - T40091/1- (quantity
2)
♦ Engine Support - Basic Set Movable Joint - T40091/3- (quan‐
tity 2)
♦ Engine Support - Supplement Kit Spindle - T40093/3- (quan‐
tity 2) from the Engine Support - Supplement Kit - T40093A-
♦ Socket - Sw15 - V/175-
♦ Engine And Transmission Holder - VAS6095-
♦ Shop Crane - VAS6100-
♦ Engine Bung Set - VAS6122-
♦ Engine and Gearbox Jack - VAS6931- or Engine/Gearbox
Jack - VAG1383A-
♦ Holding Fixture - VW313-
♦ Holding Fixture - VW540-
♦ Engine Support Brackets - T40093/3-6- (quantity 2)
♦ Hose Clamps - Up To 25mm - 3094-
♦ Not Illustrated:
♦ Brake Line Tool Kit - Pipe Cutter - VAS6056/2-
38 – Gears, Hydraulic Controls
1
ATF System
⇒ “1.1 Oil Pan, Removing and Installing”, page 84
⇒ “1.2 ATF Strainer, Removing and Installing”, page 86
1.1
Oil Pan, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
♦ Used Oil Collection and Extraction Unit - SMN372500-
♦ Used Oil Collection and Extraction Unit - SMN372500- or Drip
Tray - VAS6208-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Gasket - ATF Check Plug
Removing
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Place the Used Oil Collection and Extraction Unit -
SMN372500- or Drip Tray under the transmission.
– Remove the ATF check plug -A-.
– Remove the overflow pipe -C- and drain any remaining ATF.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст