Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 224
Installing
Install the hood -1- in reverse order of removal.
Note
Route the line -5- in a curve. If the line is installed twisted, it will kink.
– Adjust the hood -1-. Refer to
⇒ “1.4 Hood, Adjusting”, page 28
.
Tightening Specifications
1.4
Hood, Adjusting
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
♦
The vehicle must be on all four wheels when adjusting the hood.
♦
The left and right adjusting buffers -2- are not meant for adjusting. They stabilize and cushion the hood.
♦
The hood is properly adjusted when there is an overall even gap dimension when it is closed. The hood may
not be positioned too far inward or outward. The contours must also align.
♦
The hood must engage into the latch without using much force.
– Remove the catch -1-. Refer to
⇒ “1.8 Catch, Removing and Installing”, page 36
– The height of the front of the hood can be adjusted in relation
to the fenders using the lid lock -4-. Refer to
⇒ “1.6 Latch, Adjusting”, page 33
– After adjusting the hood the catch -1- can be reinstalled and
.
Tightening Specifications
Hinges, Adjusting
Note
The nuts -2- and bolts -5- are not removed, just loosened.
– If equipped, remove the caps -3 or 4-.
– By loosening the hex nuts -5- on the left and right lid hinges
-1-, the hood can be adjusted from side to side in direction of
-b arrow- and lengthwise in direction of -a arrows- between the
fenders.
– By loosening the bolts -2- on the left and right lid hinges -1-,
the hood can be adjusted in height in direction of -c arrow- and
lengthwise in direction of -a arrows- between the fenders.
– Make sure the gap dimensions are even. Refer to ⇒ Body Re‐
pair; Rep. Gr. 00 ; Body Gap Dimensions; Front Body
– After adjusting, perform corrosion protection measures on the
lid hinges -1-, the hex nuts -5- and the bolts -2-.
– If necessary, adjust the adjusting buffers.
Tightening Specifications
Adjusting Buffer, Adjusting
– Turn the adjusting buffer -1- in direction of -arrows- to adjust.
– Install and adjust the catch after adjusting the hood -2-. Refer
.
1.5
Latch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст