Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 225
Removing
– Open the hood.
– Remove the release cable from the coupling. Refer to
⇒ “1.14 Release Cable, Removing and Installing”,
.
– Disconnect the connector for the hood contact switch.
Note
The connector is secured next to the right headlamp.
– Remove the bolts -3- from the lock carrier and remove the latch
-1- upward in direction of -arrow a-.
– Unclip the bracket -5- from the latch.
– Slightly remove the bracket -5- from the latch -1- in direction
of -arrow b- and disengage the release cable -4- in direction
of -arrow c-.
– Remove the microswitch -6- from the latch.
Installing
– Engage the release cable -4- in direction of -arrow a- and
bracket -5- in the latch -1- in direction of -arrow b-.
– Install the microswitch -6- in the latch.
– Guide the latch -1- into the lock carrier in direction of
-arrow c-.
– Install the bolts -3-.
– Connect the connector for the hood contact switch -6-.
– Connect the release cable to the coupling. Refer to
⇒ “1.14 Release Cable, Removing and Installing”,
– Adjust the latch. Refer to
⇒ “1.6 Latch, Adjusting”, page 33
– Before closing the hood, make sure the hood release lever and
the release cable are working correctly.
Tightening Specifications
1.6
Latch, Adjusting
Special tools and workshop equipment required
♦ Gauge - Gap Adjustment - 3371-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
Use new bolts to adjust the latch.
– If the bolts -2- are loosened, the latch -1- can be adjusted lat‐
erally to the hood in direction of -arrow a- and in height in
direction of -b arrow-. Refer to ⇒ Body Repair; Rep. Gr. 00 ;
Body Gap Dimensions; Front Body .
Tightening Specifications
1.7
Hood Release Lever, Removing and Installing
Removing
– Pull the release lever -1- and release the hood.
– Insert a small screwdriver into the gap between the release
lever -1- and the clip -2-.
– Pry the clip -2- out of the hood release lever -1- in direction of
-arrow a- and then remove the hood release lever from the
bracket -4- in direction of -arrow b-.
It is necessary to remove the A-pillar lower trim -3- to continue
working on the bracket -4-. Refer to ⇒ Body Interior; Rep. Gr.
70 ; Passenger Compartment Trim; A-Pillar Trim Panel, Remov‐
ing and Installing .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст