Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 324
– Unclip the expanding rivet -2- and remove the center under‐
body panels.
Installing
Install in reverse order of removal.
5.3.2
Center Underbody Trim Panels, Remov‐
ing and Installing, Short Trim Panels
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
Removing
– Remove the bolts -3-.
– Unclip the expanding rivet -2- and remove the center under‐
body panels.
Installing
Install in reverse order of removal.
Component
Tightening Specification
Center underbody trim panels
to the body
2 Nm
5.4
Rear Underbody Panel, Removing and
Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
Removing
– Loosen the lock washer -3-.
– Unclip the expanding rivet -2- and remove the bolt -4-.
– Remove the rear underbody panel -1-.
Installing
Install in reverse order of removal.
Tightening Specifications
5.5
Front Tunnel Brace, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– If equipped, remove the center underbody trim panels. Refer
to
⇒ “5.3 Center Underbody Panels, Removing and Installing”,
.
– Remove the bolts -2-.
– Remove the front tunnel brace -1-.
Installing
Install in reverse order of removal.
Tightening Specifications
5.6
Rear Tunnel Brace, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст