Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 242
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– Secure the door window with adhesive tape to prevent it from
falling down.
– Switch off the ignition and all electrical equipment. Remove
the ignition key.
– Disconnect the connector -3-.
– Remove the bolts -2- (quantity: 3).
– Remove the power window motor -1- from the cable reel
mounts.
Installing
WARNING
The additional functions and pinch protection must be coded
when a new power window motor (door control module) is in‐
stalled.
– Install the window regulator motor -1- on the cable reel
mounts. Gently move the door window up and down so that
the splines between the window regulator motor and the cable
reel can mesh.
– Connect the connector -3-.
– The work procedure and notes on the one-touch up/down and
pinch protection can be found in ⇒ Maintenance ; Booklet
36.1 .
Installation is performed in reverse order of the removal.
Tightening Specifications
2.5
Window Regulator, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left window regulator. Removing and installing the
right window regulator is identical.
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– Remove the door window. Refer to
⇒ “5.4 Front Door Window, Removing and Installing”,
– Remove the window regulator motor. Refer to
⇒ “2.4 Window Regulator Motor, Removing and Installing”,
.
– Release the cable reel hooks -4- and slide into the door.
– Remove the hex nuts -5- and push the window regulator threa‐
ded pin in the door.
– Loosen the hex nuts -2-, but do not remove.
– Slide the window regulator in the door slightly upward in di‐
rection of -arrow a- and guide it into the door in direction of
-arrow b-.
– Turn the window regulator -1- 90° and remove it through the
opening in the door in direction of -arrow c-.
Installing
– Guide the window regulator -1- through the opening in the door
in direction of -arrow a- and bring it into the installation position.
– Push the window regulator threaded pin through the inner door
panel in direction of -arrow b- and push downward in direction
of -arrow c-.
– Push the threaded pin from below in the window regulator and
tighten the nuts -5-.
– Tighten the hex nuts -2-.
– Push the cable reel against the door inner panel until the hooks
-4- engage audibly.
– Install the window regulator motor. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст