Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 243
– Install the door window. Refer to
⇒ “5.4 Front Door Window, Removing and Installing”,
– Install the front door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel, Re‐
moving and Installing .
Tightening Specifications
2.6
Door Inner Cover, Removing and Instal‐
ling
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Note
The following describes removing and installing the left cover only on a 4-door vehicle. The right side and 2-
door vehicles are identical.
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– If necessary, remove the wire from the cover -1-.
– Lift the cover -1- at the bottom in direction of -arrow a-.
– Remove the cover -1- forward out of the door in direction of
-arrow b-.
Note
If it is necessary for the following work steps, remove the release cable -3- with the grommet -2- from the cover
-1-. If equipped, disconnect the connector from the grommet.
Installing
– Guide the release cable -3- with the grommet -2- into the cover
-1-.
– Install the grommet -2- into the cover -1-.
– Install the cover -1- in the door in direction of -arrow a-.
– Engage the cover -1- all around in direction of -arrow b-.
Note
Check the cover by running one's fingers along the edge.
– If equipped, install the wire on the cover -1-.
– Install the front door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel, Re‐
moving and Installing .
2.7
Catch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Cylinder Head Bolt Socket - 3410-
Note
The following describes the removal and installation of the right
catch. The left side is identical.
Removing
– Remove the bolts -2- and the catch -1-.
Installing
Note
A catch with a curve must be installed.
– Place the catch -1- with the curve facing inward on the B-pillar
-3-. Tighten the bolts -2-.
– Adjust the catch. Refer to
⇒ “1.6 Catch, Adjusting”, page 91
.
Tightening Specifications
Component
Tightening Specification
Striker pin to the body
20 Nm
2.8
Lock Cylinder Cap, Removing and Installing
Note
♦
When removing the lock cylinder cap, do not turn the screwdriver and do not use prying motions.
♦
The lock cylinder and lock cylinder cap are only installed on the driver side.
Removing
– Remove the door handle from the door.
– Gently push a small screwdriver -3- in direction of -arrow a-
into the opening on the bottom of the lock cylinder cap.
– Using the screwdriver, gently remove the lock cylinder cap
-1- from the door in direction of -arrow b- at the bottom.
– Push the cap -1- upward from the lock cylinder -2-.
Installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст