Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 226
Installing
– Slide the clip -2- into the release lever -1-.
– Push the release lever -1- onto the bracket -4-.
– Before closing the hood, make sure the hood release lever and
the release cable are working correctly.
1.8
Catch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– Open the hood -2-.
– Remove the bolts -3-.
– Remove the catch -1- from the hood -2-.
Installing
Install the catch -1- in reverse order of removal.
– Adjust the catch. Refer to
⇒ “1.9 Catch, Adjusting”, page 38
Tightening Specifications
1.9
Catch, Adjusting
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
– Loosen the bolts -2-.
– Adjust the hood catch -1- on the hood -2- sideways inside the
oblong hole in direction of -arrows-.
Tightening Specifications
1.10
Hinges, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
The following describes the removal and installation of the right
hinge. Removing and installing the left hinge is identical.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст