Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 855
– Press the tabs -arrows- on the assembly aid -1- inward.
– Remove the assembly aid -1- upward.
– Position the - VAS6931- or -VAG1383A- under the transverse
link and push lightly upward.
– Insert the Spring Compressor -3-.
1 - -VAG1752/3A-
2 - -VAG1752/9-
3 - -VAG1752/1-
4 - Spring
WARNING
Make sure the coil spring is seated correctly in the -
VAG1752/3A- -arrow- (danger of accident).
Note
Use a wrench or a reversible ratchet to tighten the spring com‐
pressor.
– Tension the coil spring.
– Remove the nut -1- and then the bolt -2- for the coupling rod
-3-.
– Remove the nut -1- and then the bolt -2- for the shock absorber
threaded connection.
– Remove the nut -3- and then the bolt -4- for the wheel bearing
housing threaded connection.
WARNING
Hold the -VAG1752/1- with the spring tensioned (risk of acci‐
dent).
– Slowly lower the -VAS6931- or -VAG1383A- under the lower
transverse link, until the -VAG1752/1- with the tensioned
spring can be removed.
Installing
Install in reverse order of removal. Note the following:
– Make sure the washer is not damaged.
– Replace the washer if necessary.
– Install the washer on the coil spring.
The spring start -arrow- must touch the stop of lower spring sup‐
port.
– Install the spring and the spring support.
– Spring seat has a pin on bottom.
– Insert this pin into hole of lower transverse link -arrow-.
– Insert the top of the spring support into the upper spring end.
– The bead on the spring support -arrow- must fit into the coil
spring correctly.
WARNING
Hold the -VAG1752/1- with the spring tensioned (risk of acci‐
dent).
– Push the - VAS6931- or -VAG1383A- under the transverse link
upward.
– Insert the bolt -4- for connecting the wheel bearing housing
and tighten the nut -3-.
– Insert the bolt -2- for connecting the shock absorber and tight‐
en the nut -1-.
– Insert the bolt -2- for the coupling rod -3- and tighten the nut
-1-.
– Release the tension on the spring -4- while positioning the up‐
per spring support onto tab of body.
– Remove the Spring Tensioner -3-.
1 - -VAG1752/3A-
2 - -VAG1752/9-
3 - -VAG1752/1-
4 - Spring
– Insert the assembly aid -1- and push downward.
– The tabs -arrows- must engage.
– For vehicles with a level control system sensor, perform the
basic setting for the wheel damping electronics using the Ve‐
hicle Diagnostic Tester.
Tightening Specifications
♦ Refer to
⇒ “4.1 Overview - Stabilizer Bar”, page 177
♦ Refer to
⇒ “5.1 Overview - Transverse Link”, page 181
♦ Refer to
⇒ “6.1 Overview - Suspension Strut, Shock Absorber and
♦ Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст