Volkswagen Jetta / Jetta Hybrid. Manual — part 15
1 - Gas strut
❑ Removing and installing
⇒ page 57
❑ Releasing gas
⇒ page 60
2 - Ball-head pin
❑ Only at right hinge
❑ Cannot be separated
from hinge
3 - Retaining bracket with ball-
head pin
❑ On rear wall
❑ Cannot be separated
from rear wall
2.5
Removing and installing gas strut
2.5.1
Removing
Note
The rear lid must be supported if a gas strut is removed.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Rear lid
57
be levered completely out of ball socket, as it will otherwise be
damaged. Gas strut will spring out of mounting, causing dam‐
age or injury to operator.
Carry out following work:
– Open rear lid and brace it open.
– Position a small screwdriver -3- beneath spring clips -2-.
– Raise spring clips -2- until spring clips can be moved over ball
sockets.
– Pull gas strut -1- off ball-head pin.
After removing gas strut, slide spring clips -2- back immediately.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
58
be levered completely out of ball socket, as it will otherwise be
damaged. Gas strut will spring out of mounting, causing dam‐
age or injury to operator.
– Releasing gas from gas strut
⇒ page 60
2.5.2
Installing
Carry out following work:
• Push spring clips -2- onto ball sockets of gas strut -1-.
– Push ball sockets of gas strut -1- onto ball-head pins until ball
sockets audibly engage with the ball-head pins.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Rear lid
59
– Clamp gas strut in vice in area x = 50 mm.
WARNING
Clamp gas strut only within area -x-; otherwise danger of ac‐
cident!
– Saw through cylinder of gas strut within first third of cylinder's
overall length using piston rod end of cylinder as reference
point.
Note
♦
Wear eye protection when sawing.
♦
Cover area of saw cut with a cloth.
♦
Dispose of oil and cloth via existing disposal channels.
2.7
Assembly overview - rear lid hinge
1 - Rear lid
❑ Removing and installing
⇒ page 55
❑ Adjusting
⇒ page 64
2 - Bolt
❑ Qty. 2 for each hinge.
❑ Specified torque: 9 Nm
3 - Hinge
❑ Removing and installing
⇒ page 61
4 - Gas strut
❑ Removing and installing
⇒ page 57
❑ Releasing gas
⇒ page 60
5 - Electrical wiring
❑ Clipped in place on
hinge
6 - Bolt
❑ Qty. 4 for each hinge.
❑ Specified torque: 9 Nm
7 - Spring
❑ Left and right.
❑ Engage in left hole
-arrow-
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
60
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст