Geely Emgrand X7. Manual part — 299
Geely Emgrand X7. Manual part - 299
Installation procedure::
1. Use a flat-panel jack to support the transmission
assembly.
2. Insert the transmission input shaft into the clutch
plates. Push the transmission to the engine end,
pay attention to position of locating pin.
NL03-0172b
3. Install the rear connecting bolt of transmission ;
NL03-0025b
4. Install transmission lower connecting bolt and
start motor lower fixing bolt.
NL03-0026b
1195
5. Install start fixing bolt and cable on the start
motor
6. Dismantle the flat-panel jack;
FE03-0180b
NL03-0027 b
7. Install transmission housing grounding cable.
8. Install the left and right drive shafts.
9. Install front suspension longitudinal beam.front
subframe and related connecting part.
10. Install the front wheel tire.
11. Dismantle engine hoisting tool.
NL03-0028b
12. Install the transmission upper connecting bolts;
NL03-0029b
1196
13. Install the transmission left bracket assembly.
NL03-0018b
14. install and tighten fixing support of clutch slave
pump
15. Install the clutch slave pump and exhaust the air.
16. Install the shift control mechanism.
17. Install crankshaft position sensor harness
connector.
18. Install speed sensor harness connector.
19. Install reverse door lamp switch harness
connector.
20. Install the battery base plate.
21. Connect the battery negative cable.
NL03-0014b
1197
3.4.8.4 Shift control mechanism assembly replacement
Dismantle procedure
Warning: refer to warning for battery disconnection in warnings and precautions.
1. Disconnect the battery negative cable. Refer to
2.11.8.1 battery cable disconnection/connection
procedures.
2. Dismantle
air
filter.
NL03-0031b
3. Dismantle shift lever and selecting rod cable
plug.
NL03-0032b
4. Dismantle fixing clip plate of shift lever cable
position .take out shift control lever cable.
NL03-0033b
1198
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст