Geely Emgrand X7. Manual part — 536
Geely Emgrand X7. Manual part - 536
8. Connect the headlight assembly
lower electrical wire harness
connector and press into
connector bayonet lock.
NL11-0270b
9. Connect the upper harness
connector of the headlight.
NL11-0271b
10. Install front fender bushing
trimming plate and press fixing
buckle.
11. Install front bumper.
12. Connect the battery negative
cable.
Notes:
Adjust the headlamps harness after
installation.
Notes:
The method for replacing the front
position lamp and the front steering
signal lamp is the same as that for
replacing the headlamp; and the
replacement procedure refers to
"replacement of headlamp".
NL11-0263b
2143
11.4.8.8 Replacement of rear combination lamp
Dismantlement procedure
Warning!
Warning: refer to warning on battery disconnection in warnings and precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. For dismantling of lower
trimming plate of rear column,
refer to 12.9.1.5 replacement of
lower trimming plate of rear
column.
3. Disconnect the rear combination
lamp harness connector.
NL11-0272b
4. Dismantle fixing nut inside rear
combined lamp.
NL11-0273b
5. Remove the external fixing bolt
for the rear assembled lamp.
6. Remove the assembled lamp.
NL11-0274b
2144
7. Unscrew the back cover of the
rear assembled lamp and
dismantle the bulb.
NL11-0275b
Installation procedure:
1. Assemble bulb into rear
combined lamp assembly.
Notes:
Avoid contacting the bulb or having it
get in contact with any wet item.
When the lamp is turned on, the skin
grease or moisture on the bulb may
cause the bulb explode. If the bulb
contacts with grease or moisture, clean
the bulb with alcohol or an appropriate
cleaning agent and dry the bulb.
NL11-0275b
2. Install rear combined lamp
assembly and tighten external
fixing screw.
Torque: 3Nm (Metric system) 2.2lb-ft
(English system)
NL11-0274b
2145
3. Install fixing nut inside rear
combined lamp.
Torque: 3Nm (Metric system) 2.2lb-ft
(English system)
NL11-0273b
4. Connect the harness connector
for the rear combination lamp
assembly.
5. Install the rear column lower trim
panel.
6. Connect the battery negative
cable.
7. If you want to only replace the
rear assembled bulb, you may
directly open the rear assembled
lamp decorative cover.
NL11-0276b
2146
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст