Geely EC718, EC718RV, EC715, EC715RV. Manual part — 108
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 108
FE02-0125b
7.
Install the crankcase ventilation tube.
8.
Install the throttle body.
9.
Install the engine hood.
10. Install the battery negative cable.
2.6.8.7 Engine Mount Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in "Warnings
and Notices".
FE02-0126b
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the engine hood. Refer to
.
3.
Support the engine assembly with a jack.
Note
Before jacking the engine, place a piece of wood
between the jack and the engine oil pan, otherwise
it will damage the engine oil pan.
FE02-0127b
4.
Remove the engine to body right mount bolts.
Engine
Engine Mechanical System JL4G18-D
2-347
FE02-0128b
5.
Remove the engine mount to engine right retaining bolts
and nuts.
FE02-0129b
6.
Remove the drive belt. Refer to
7.
Remove the drive belt tensioner. Refer to
8.
Remove the generator bracket bolts.
FE02-0130b
9.
Remove the engine mount retaining bolts and remove the
engine mount.
2-348
Engine Mechanical System JL4G18-D
Engine
Installation Procedure:
FE02-0131b
1.
Install and tighten the engine mount retaining bolts to the
specified torque.
Torque: 47 Nm (Metric) 34.8 lb-ft (US English)
FE02-0132b
2.
Install the generator bracket bolts.
Torque: 47 Nm (Metric) 34.8 lb-ft (US English)
FE02-0128b
3.
Install the drive belt tensioner.
4.
Install the drive belt.
5.
Install and tighten the right engine mount to the engine
retaining bolts and nuts.
Bolts
Torque: 52 Nm (Metric) 38.5 lb-ft (US English)
Nuts
Torque: 52 Nm (Metric) 38.5 lb-ft (US English)
Engine
Engine Mechanical System JL4G18-D
2-349
FE02-0134b
6.
Install and tighten the right engine mount to the body bolts.
Torque: 52 Nm (Metric) 38.5 lb-ft (US English)
7.
Remove the supporting jack.
8.
Install the engine hood.
9.
Install the battery negative cable.
2.6.8.8 Timing Chain Tensioner Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in "Warnings
and Notices".
FE02-0135b
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the engine hood. Refer to
.
3.
Remove the ignition coil. Refer to
4.
Remove the cylinder head cover. Refer to
5.
Rotate the crankshaft and make sure the cylinder No.1 is
at TDC position.
Note
Crankshaft timing mark is aligned with the timing
chain cast scale line "0".
2-350
Engine Mechanical System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст