Geely EC718, EC718RV, EC715, EC715RV. Manual part — 115
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 115
FE02-0472b
19. Remove the fuel pipe.
FE02-0473b
20. Remove the canister vacuum tubes.
FE02-0474b
21. Remove shift lever pull cable.
Engine
Engine Mechanical System JL4G18-D
2-375
FE02-0475b
22. Remove the throttle cable.
FE02-0476b
23. Remove the heater intake and outlet pipes.
FE02-0477b
24. Remove the front wheels.
25. Lift the vehicle.
Warning!
Refer to "Vehicle Lifting Warning" in "Warnings and
Notices".
26. Remove the gearbox oil discharge bolt until all the
gearbox oil is discharged and reinstall. Refer to
Transmission Fluid Level Inspection
27. Remove the steering cross pin bolts.
Warning!
Before remove the steering cross pin bolt, remove
the key from the ignition switch first and turn the
steering wheel to lock position. Otherwise it will
damage the airbag clock spring.
2-376
Engine Mechanical System JL4G18-D
Engine
FE02-0478b
28. Remove the front subframe and related components.
.
FE02-0479b
29. Remove the left and right side drive shafts. Refer to
".
30. Place a mobile working table under the engine assembly
to lower and support the powertrain assembly.
Note
Make sure solid contact between the working table
and the powertrain assembly, otherwise it will result
in bodily injury.
31. Remove the right engine mount assembly.
FE02-0480b
32. Remove the left gearbox mount assembly.
Engine
Engine Mechanical System JL4G18-D
2-377
FE02-0481b
33. Slowly lift the vehicle to separate the powertrain from the
vehicle body.
Note
In the lifting process, avoid the powertrain assembly
tilt on the working table. Pay attention to the
powertrain and vehicle body interference.
34. Use an engine lifting device to support the engine and
then separate the engine and the gearbox. Refer to
Transmission Assembly Replacement
.
Installation Procedure:
FE02-0479b
1.
Use the engine lifting device to support the engine and
then assemble the engine and the gearbox assembly.
2.
Place the powertrain assembly on the mobile working
table, lift the vehicle and move the working table so the
powertrain assembly moves back into the vehicle body
frame.
3.
Slowly lower the vehicle. Pay attention in the lowering
process, do not interfere with the vehicle body frame.
Note
Make sure solid contact between the working table
and the powertrain, otherwise it will result in bodily
injury.
4.
Install the right engine mount assembly.
FE02-0480b
5.
Install the left gearbox mount assembly.
2-378
Engine Mechanical System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст